EN15000G - No Post

sfw · #1 (**permalink**) 28-09-08, 02:26 AM

Hi there:

I just purchased an EPIA EN15000G board for a project I am working on. I installed 256MB of RAM and a 250W ATX PSU along with a keyboard, mouse & CRT monitor just to check if the board will post in to BIOS.

Unfortunately, when I power up, the fans spin and the LED lights are on, but nothing happens on the CRT. There are no beeps.

Am I doing something wrong?

sfw · #2 (**permalink**) 28-09-08, 01:28 PM

I may be doing this wrong - can someone please tell me what pins on the motherboard I should attach the PWR SWTCH, PWR LED, HDD LED, RESET SWTCH, SPKR, etc to?

The manual was very vague - any help would be appreciated. Thank you

aa1ww · #3 (**permalink**) 22-10-08, 04:18 PM

I have used VIA mainboards (CN, EN, & EX though my EN board was fanless). My cpu fans don't start until I press the power-on button attached to the front-panel connector (very similar on all VIA mainboards). Did you get your board new? You might also consider restting the CMOS RAM to default/factory settings (unless a knowledgeable person advises you differently). If you do this, BE CAREFUL to follow the instructions in the VIA EN User's Manual.