Got the following error while running prime95

[cas]

The above are the cas timing and voltage which i've set manually, could u kindly advise me on the above? Though it seem to be able to run prime95 longer after cranking up the cpu voltage more but if i were to crank abit more up it would reaches the redlline which is deem as unstable or danger Could i crank ill the red warning line?

[Jomo]

Put your memory timings at 5-5-5-15

You may also need to run your vcore higher, to bench at 4ghz I need 1.6 volts.

I wouldn't go cranking up the vcore much more, I'm sure your temps are pretty high.

[cas]

Would do, other than setting the memory timing as u mention, what about the
Dram trfc
Dram twr
Dram twtr
Dram trrd
dram trtp

Should those setting be change as well?

Yup i would luv to crank the vcore higher but then the next stage would be reaching the red warning which i've mention earlier on, so is it safe to crank it at those red numeric?

Lastly u're absoutely right, the temp now for both core is within 80, 80- 82, 82 judging from coretemp Arghhhhh after running stable for 54 minute, workthread 2 went dead again

[Jomo]

You can leave those timings at stock, but it doesn't really matter since your going to smoke your cpu at those temps.

[cas]

Originally Posted by Jomo

You can leave those timings at stock, but it doesn't really matter since your going to smoke your cpu at those temps.

Hey Jomo tks for the tip since my last thread and have follow ur guidance using the above memory timing as well as cranking the vcore more, since then it has been running till now, hmm guess approximately 2hr? Both core running fine but what worries me is the high temp, from 83-100 gosh.... but surprisngly i dun encounter any bsod, shutdown. Should i continue with the testing given the temp is so high?

[Jomo]

If you run your cpu at those temps it's just a matter of time before it dies and it will.

[cas]

Originally Posted by Jomo

If you run your cpu at those temps it's just a matter of time before it dies and it will.

Ok guess is time to stop for the time being, 3hr of running, no crash so far so good. Tbh i'm using a intel stock hs for the test. Most probably getting a cooler next week, what do u think of the Scythe Ninja or u have any recommendation? (old question again,lol)

I knew the Thermalright 120 Extreme is oe of the best cooler around but then i would have to change my case if i get those

[Jomo]

The Ultima 90, but I'm not sure it'll fit. It's still asking alot of an air cooler to keep those temps down.

Your also putting alot of stress on your psu, and you have to consider how hot your northbridge is running.

[cas]

Originally Posted by Jomo

The Ultima 90, but I'm not sure it'll fit. It's still asking alot of an air cooler to keep those temps down.

Your also putting alot of stress on your psu, and you have to consider how hot your northbridge is running.

Have tot of that before, so how do i ensure the north or south bridge is not heating up, dun tell me i need to take off the hs and replace it with a fan? What about the ram and graphic, both of these would be hot and stress as well?

[cas]

Into 11 hr of test from morning 9 plus till now, hmm should i stop now or should i let it carry on with the test? No crashes and both workthread has been running fine with all the test pass but then the temp is still within 83 range judging from coretemp

Is the temp exact, if is indeed so high why yet i'm still able to continue with the test for the past 11 hr without crashing, hmmm.....